Manual Water Dosage Unit WD

Manual Water Dosage Unit WD


Control device for manual moisturing of grain

The water dosage unit is used to moisten grain manually. The dosing unit is connected to the drinking water pipe. Any water flow rate can be set. The water flow is initiated by actuating a solenoid valve.

 

Assembly:
The water dosage unit can be assembled at any place between water supply and intensive dampener.

Electrical connection:
For control of the solenoid valve a mains connection of 230 V / 1 A is required. It is recommendable to connect this valve to a capacitive proximity switch. This proximity switch must be assembled so that is switches when grain is running through the intensive dampener.

The correct water flow in l / h is set by the following calculation:
Grain flow in t/h x target % of water addition x 12


If you use this contact form, you will send us data. We save your contact information only for this purpose. We do not share this information. We will not share this information without your consent. For more information, visit the Privacy Policy page.


I agree to the above use of the data! Required!